GB/T 7343-1987
AbolishedMethods of measurement of the suppresion characteristics of passive radio interference filters and suppression components over the frequency range of 10kHz to 30MHz
10 kHz～30 MHz无源无线电干扰滤波器和抑制元件抑制特性的测量方法
Application Summary AI generated
This standard specifies measurement methods for evaluating the suppression characteristics of passive radio interference filters and suppression components within the 10 kHz to 30 MHz frequency range. It is applied in the electronics industry for testing and qualifying components used in equipment such as power supplies, communication devices, and household appliances to ensure compliance with electromagnetic compatibility (EMC) requirements. The standard is particularly relevant for manufacturers and testing laboratories assessing the performance of filters and suppressors in reducing conducted radio interference.
Related Standards
GB/T 17190-1997
Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system for electronic components--Part 1:Generic specification--Qualification approval
GB/T 12865-1997
Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system forelectronic components--Part 2:Sectional specification--Qualification approval--Section 1:Blank detail specification--Assessment level E
GB/T 12864-1997
Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system for electronic components--Part 2:Sectional specification--Qualification approval
GB/T 15288-1994
Complete filter units for radio interference suppression--Part 2:Sectional specification--Selection of methods of test and general requirements
GB/T 15287-1994
Complete filter units for radio interference suppression--Part 1:Generic specification
GB/T 32988-2016
Synthetic quartz crystal wafer for optical low pass filter (OLPF)
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.