GB/T 12864-1997

Active

Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system for electronic components--Part 2:Sectional specification--Qualification approval

电子设备用压电陶瓷滤波器 电子元器件质量评定体系规范 第2部分:分规范 鉴定批准

Standard Type
GBT
ICS
31.160
CCS
L18
Status
Active
Issue Date
1997-12-26
Implementation
1998-10-01
Centralized Committee
工业和信息化部（电子）
Issuing Authority
工业和信息化部（电子）

Application Summary AI generated

This standard specifies the quality assessment procedures and requirements for piezoelectric ceramic filters used in electronic equipment, focusing on qualification approval within the electronic components quality assessment system. It is applied in the manufacturing and testing of filters for consumer electronics, telecommunications, and audio devices to ensure consistent performance and reliability. The standard provides a sectional specification framework for evaluating these filters under controlled conditions.

Related Standards

GB/T 17190-1997 Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system for electronic components--Part 1:Generic specification--Qualification approval GB/T 12865-1997 Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system forelectronic components--Part 2:Sectional specification--Qualification approval--Section 1:Blank detail specification--Assessment level E GB/T 15288-1994 Complete filter units for radio interference suppression--Part 2:Sectional specification--Selection of methods of test and general requirements GB/T 15287-1994 Complete filter units for radio interference suppression--Part 1:Generic specification GB/T 7343-1987 Methods of measurement of the suppresion characteristics of passive radio interference filters and suppression components over the frequency range of 10kHz to 30MHz GB/T 32988-2016 Synthetic quartz crystal wafer for optical low pass filter (OLPF)
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.