GB/T 15288-1994
ActiveComplete filter units for radio interference suppression--Part 2:Sectional specification--Selection of methods of test and general requirements
抑制射频干扰整件滤波器 第二部分:分规范 试验方法的选择和一般要求
Application Summary AI generated
This standard specifies the selection of test methods and general requirements for complete filter units designed to suppress radio interference. It is applied in the electronics industry for testing and qualifying filters used in equipment to meet electromagnetic compatibility (EMC) regulations, ensuring that conducted and radiated interference is minimized.
Related Standards
GB/T 17190-1997
Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system for electronic components--Part 1:Generic specification--Qualification approval
GB/T 12865-1997
Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system forelectronic components--Part 2:Sectional specification--Qualification approval--Section 1:Blank detail specification--Assessment level E
GB/T 12864-1997
Piezoelectric ceramic filters for use in electronic equipment--A specification in the quality assessment system for electronic components--Part 2:Sectional specification--Qualification approval
GB/T 15287-1994
Complete filter units for radio interference suppression--Part 1:Generic specification
GB/T 7343-1987
Methods of measurement of the suppresion characteristics of passive radio interference filters and suppression components over the frequency range of 10kHz to 30MHz
GB/T 32988-2016
Synthetic quartz crystal wafer for optical low pass filter (OLPF)
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.