GB/T 20111.3-2016
ActiveElectrical insulation systems—Procedures for thermal evaluation—Part 3: Specific requirements for encapsulated–coil model—Wire–wound electrical insulation system (EIS)
电气绝缘系统 热评定规程 第3部分：包封线圈模型的特殊要求 散绕绕组电气绝缘系统（EIS）
Application Summary AI generated
This standard specifies the test procedures and performance requirements for evaluating the thermal endurance of wire-wound electrical insulation systems (EIS) used in encapsulated coils. It is applied in the electrical engineering industry, particularly for motors, transformers, and other electromagnetic devices, to ensure insulation reliability under thermal stress during product qualification and life-cycle testing.
Related Standards
GB/T 19443-2004
Insulators for overhead lines with a nominal voltage above 1000V--Ceramic or glass insulator units for d.c. systems--Difinitions，test methods and acceptance criteria
GB/T 4585-2004
Artificial pollution tests on high-voltage insulators to be used on a.c. systems
GB/Z 23756.1-2009
Evaluation of electrical endurance of electrical insulation systems - Part 1: General considerations and evaluation procedures based on normal distributions
GB/Z 16935.2-2013
Insulation coordination for equipment within low-voltage systems―Part 2-1: Application guide-Explanation of the application of the IEC 60664 series, dimensioning example and dielectric testing
GB/Z 16935.6-2016
Insulation coordination for equipment within low-voltage systems—Part 2-2: Interface considerations—Application guide
GB/Z 37754-2019
Guidance on clearances and creepage distances in particular for distances equal to or less than 2mm—Test results of research on influencing parameters
GB/Z 43963-2024
Guidance for determination of clearances, creepage distances and requirements for solid insulation for equipment with a rated voltage above 1 000 V AC and 1 500 V DC, and up to 2 000 V AC and 3 000 V DC
GB/T 775.2-2003
Test method for insulators--Part2: Electrical test methods
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.