GB/Z 37754-2019
ActiveGuidance on clearances and creepage distances in particular for distances equal to or less than 2mm—Test results of research on influencing parameters
关于确定不超过2mm距离的电气间隙和爬电距离的指南 对影响参数进行研究的试验结果
Application Summary AI generated
This standard provides guidance on determining electrical clearances and creepage distances for spacings of 2mm or less, based on research into influencing parameters like humidity and pollution. It is applied in the design and testing of compact electrical and electronic equipment, such as printed circuit boards and connectors, where precise insulation coordination is critical for safety and reliability.
Related Standards
GB/T 19443-2004
Insulators for overhead lines with a nominal voltage above 1000V--Ceramic or glass insulator units for d.c. systems--Difinitions，test methods and acceptance criteria
GB/T 4585-2004
Artificial pollution tests on high-voltage insulators to be used on a.c. systems
GB/Z 23756.1-2009
Evaluation of electrical endurance of electrical insulation systems - Part 1: General considerations and evaluation procedures based on normal distributions
GB/Z 16935.2-2013
Insulation coordination for equipment within low-voltage systems―Part 2-1: Application guide-Explanation of the application of the IEC 60664 series, dimensioning example and dielectric testing
GB/Z 16935.6-2016
Insulation coordination for equipment within low-voltage systems—Part 2-2: Interface considerations—Application guide
GB/Z 43963-2024
Guidance for determination of clearances, creepage distances and requirements for solid insulation for equipment with a rated voltage above 1 000 V AC and 1 500 V DC, and up to 2 000 V AC and 3 000 V DC
GB/T 775.2-2003
Test method for insulators--Part2: Electrical test methods
GB/T 1001.1-2003
Insulators for overhead lines with a nominal voltage above 1000V--Part 1: Ceramic or glass insulator units for a.c.systems--Definitions，test methods and acceptance criteria
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.