GB/T 25189-2010
ActiveMicrobeam analysis - Determination method for quantitative analysis parameters of SEM-EDS
微束分析 扫描电镜能谱仪定量分析参数的测定方法
Application Summary AI generated
This standard specifies the method for determining quantitative analysis parameters in scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDS). It is applied in microbeam analysis within materials science, metallurgy, and geology to ensure accurate elemental composition measurements. The standard is used by laboratories and quality control facilities for calibrating SEM-EDS instruments and validating quantitative results.
Related Standards
GB/T 20724-2006
Method of thickness measurement for thin crystal by convergent beam electron diffraction
GB/T 28727-2012
Gas analysis - Determination of sulfides - Gas chromatograph with flame photometric detector
GB/T 14666-2003
Terms for analytical chemistry
GB/T 674-2003
Chemical reagent--Copper(II)oxide powder
GB/T 656-2003
Chemical reagent--Ammonium dichromate
GB/T 1265-2003
Chemical reagent--Sodium bromide
GB/T 606-2003
Chemical reagent--General method for the determination of water--Karl Fischer method
GB/T 19502-2004
Surface chemical analysis--Glowdischarge optical emission spectrometry(GD-OES)--Introduction to use
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.