GB/T 23718.1-2009
ActiveCondition monitoring and diagnostics of machines - Requirements for training and certification of personnel - Part 1: Requirements for certifying bodies and the certification process
机器状态监测与诊断 人员培训与认证的要求 第1部分：对认证机构和认证过程的要求
Application Summary AI generated
This standard specifies the requirements for organizations that certify personnel in machine condition monitoring and diagnostics, ensuring the certification process is consistent, transparent, and reliable. It is applied by certification bodies and industrial sectors (e.g., manufacturing, power generation, or transportation) that need to formally validate the competence of technicians performing vibration analysis, oil analysis, or thermography. The standard governs the structure, procedures, and quality management of the certification process itself, rather than the technical skills of the individuals.
Related Standards
GB/T 20485.12-2008
Method for the calibration of vibration and shock transducers - Part 12: Primary vibration calibration by the reciprocity method
GB/T 14412-2005
Mechanical vibration and shock-Mechanical mounting of accelerometers
GB/T 13823.1-2005
Methods for the calibration of vibration and shock transducers part 1:Basic concepts
GB/T 6075.6-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 6:Reciprocating machines with power ratings above 100kW
GB/T 6075.5-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 5:Machine sets in hydraulic power generating and pumping plants
GB/T 6075.2-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 2:Large land-based steam turbine generator setsin excess of 50MW
GB/T 6075.4-2001
Mechanical vibration--Evaluation of machine vibration by measurementson non-rotating parts--Part 4:Gas turbine driven sets excluding aircraft derivatives
GB/T 6075.3-2001
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 3:Industrial machines with nominal power above 15kW and nominal speeds between 120r/min and 15000r/min when measured in situ
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.