GB/T 19290.6-2018

Active

Modular order for the development of mechanical structures for electronic equipment practices—Part 2-4: Sectional specification—Interface co-ordination dimensions for the 25 mm equipment practice—Adaptation dimensions for subracks or chassis applicable in cabinets or racks in accordance with IEC 602

发展中的电子设备构体机械结构模数序列 第2-4部分:分规范 25 mm设备构体的接口协调尺寸 适用于符合IEC 60297-3-100(19 in)机柜或机架的插箱或机箱的适配尺寸

Standard Type
GBT
ICS
31.240
CCS
K05
Status
Active
Issue Date
2018-12-28
Implementation
2019-07-01
Centralized Committee
国家标准委
Issuing Authority
国家市场监督管理总局、中国国家标准化管理委员会

Application Summary AI generated

This standard specifies the adaptation dimensions for subracks or chassis designed to fit into 19-inch cabinets or racks that comply with IEC 60297-3-100. It is applied in the electronics industry to ensure mechanical interface coordination and interoperability for 25 mm equipment practice, enabling consistent mounting and integration of modular electronic assemblies.

Related Standards

GB/T 19247.1-2003 Printed board assemblies--Part 1: Generic specification--Requirements for soldered electrical and electronic assemblies using surface mount and related assembly technologies GB/T 19247.2-2003 Printed board assemblies--Part 2: Sectional specification--Requirements for surface mount solderedassemblies GB/T 19290.1-2003 Modular order for the development of mechanical structures for electronic equipment practices--Part 1: Generic standard GB/T 3047.3-2003 Series of basic dimensions of subracks and plug-in units for vertical increment of 20mm GB/T 19290.2-2003 Modular order for the development of mechanical structures for electronic equipment practices--Part 2: Sectional specification--Interface co-ordination dimensions for the 25mm equipment practice GB/T 3047.5-2003 Series of basic dimensions of cabiners for vertical increment of 20mm GB/T 19247.3-2003 Printed board assemblies--Part 3:Sectional specification--Requirements for through-hole mount soldered assemblies GB/T 19247.4-2003 Printed board assemblies--Part 4:Sectional specification--Requirements for terminal soldered assemblies
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.