GB/T 19290.3-2008

Active

Modular order for the development of mechanical structures for electronic equipment practices - Part 2-1: Sectional specification - Interface co-ordination dimensions for the 25 mm equipment practice - Detail specification - Dimensions for cabinets and racks

发展中的电子设备构体机械结构模数序列 第2-1部分：分规范 25mm设备构体的接口协调尺寸 详细规范 机柜和机架的尺寸

Standard Type
GBT
ICS
31.240
CCS
K05
Status
Active
Issue Date
2008-11-13
Implementation
2009-11-01
Centralized Committee
国家标准委
Issuing Authority
中华人民共和国国家质量监督检验检疫总局、中国国家标准化管理委员会

Application Summary AI generated

This standard specifies the interface coordination dimensions for cabinets and racks within the 25 mm equipment practice, ensuring mechanical interchangeability and compatibility between enclosures and subracks. It is applied in the design and manufacturing of electronic equipment structures, particularly for telecommunications, data processing, and industrial control systems that require standardized mounting and integration of modular components. The standard facilitates consistent physical interfaces across different manufacturers' products, enabling reliable assembly and maintenance in rack-based installations.

Related Standards

GB/T 19247.1-2003 Printed board assemblies--Part 1: Generic specification--Requirements for soldered electrical and electronic assemblies using surface mount and related assembly technologies GB/T 19247.2-2003 Printed board assemblies--Part 2: Sectional specification--Requirements for surface mount solderedassemblies GB/T 19290.1-2003 Modular order for the development of mechanical structures for electronic equipment practices--Part 1: Generic standard GB/T 3047.3-2003 Series of basic dimensions of subracks and plug-in units for vertical increment of 20mm GB/T 3047.5-2003 Series of basic dimensions of cabiners for vertical increment of 20mm GB/T 19290.2-2003 Modular order for the development of mechanical structures for electronic equipment practices--Part 2: Sectional specification--Interface co-ordination dimensions for the 25mm equipment practice GB/T 19247.3-2003 Printed board assemblies--Part 3:Sectional specification--Requirements for through-hole mount soldered assemblies GB/T 19247.4-2003 Printed board assemblies--Part 4:Sectional specification--Requirements for terminal soldered assemblies
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.