GB/T 19183.1-2003

Abolished

Mechanical structures for electronic equipment--Outdoor enclosures--Part 1: Design guidelines

电子设备机械结构 户外机壳 第1部分:设计导则

Standard Type
GBT
ICS
31.240
CCS
K05
Status
Abolished
Issue Date
2003-06-05
Implementation
2004-01-01
Centralized Committee
国家标准委
Issuing Authority
中华人民共和国国家质量监督检验检疫总局

Application Summary AI generated

This standard provides design guidelines for outdoor enclosures used to house electronic equipment, focusing on structural integrity, environmental protection, and thermal management. It is applied by engineers and manufacturers in the electronics industry when designing cabinets or housings for telecommunications, power distribution, or industrial control systems that must withstand outdoor conditions like rain, dust, and temperature extremes. The standard ensures consistent design practices for enclosures intended for permanent outdoor installation, facilitating reliability and interoperability across different equipment types.

Related Standards

GB/T 19247.1-2003 Printed board assemblies--Part 1: Generic specification--Requirements for soldered electrical and electronic assemblies using surface mount and related assembly technologies GB/T 19247.2-2003 Printed board assemblies--Part 2: Sectional specification--Requirements for surface mount solderedassemblies GB/T 3047.3-2003 Series of basic dimensions of subracks and plug-in units for vertical increment of 20mm GB/T 19290.2-2003 Modular order for the development of mechanical structures for electronic equipment practices--Part 2: Sectional specification--Interface co-ordination dimensions for the 25mm equipment practice GB/T 3047.5-2003 Series of basic dimensions of cabiners for vertical increment of 20mm GB/T 19290.1-2003 Modular order for the development of mechanical structures for electronic equipment practices--Part 1: Generic standard GB/T 19247.3-2003 Printed board assemblies--Part 3:Sectional specification--Requirements for through-hole mount soldered assemblies GB/T 19247.4-2003 Printed board assemblies--Part 4:Sectional specification--Requirements for terminal soldered assemblies
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.