GB/T 17360-2020
ActiveMicrobeam analysis—Method of quantitative determination for low contents of silicon and manganese in steels using electron probe microanalyzer
微束分析 钢中低含量硅、锰的电子探针定量分析方法
Application Summary AI generated
This standard specifies the quantitative method for determining low contents of silicon and manganese in steel using an electron probe microanalyzer. It is applied in metallurgical analysis and materials science for quality control and research, particularly when analyzing micro-areas of steel samples where traditional bulk chemical methods are insufficient. The standard ensures accurate and reproducible measurements of these elements at low concentration levels.
Related Standards
GB/T 20724-2006
Method of thickness measurement for thin crystal by convergent beam electron diffraction
GB/T 28727-2012
Gas analysis - Determination of sulfides - Gas chromatograph with flame photometric detector
GB/T 14666-2003
Terms for analytical chemistry
GB/T 674-2003
Chemical reagent--Copper(II)oxide powder
GB/T 1265-2003
Chemical reagent--Sodium bromide
GB/T 656-2003
Chemical reagent--Ammonium dichromate
GB/T 606-2003
Chemical reagent--General method for the determination of water--Karl Fischer method
GB/T 19502-2004
Surface chemical analysis--Glowdischarge optical emission spectrometry(GD-OES)--Introduction to use
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.