GB/T 15292-1994
AbolishedMeasuring methods for thyristor--Reverse conducting triode thyristor
晶闸管测试方法 逆导三极晶闸管
Application Summary AI generated
This standard specifies the test methods for measuring the electrical parameters of reverse conducting triode thyristors, including turn-off time, reverse recovery charge, and on-state voltage. It is applied in the manufacturing and quality inspection of power semiconductor devices used in high-frequency inverters, choppers, and motor control circuits. The standard ensures consistent performance evaluation for these components in industrial electronics and power conversion systems.
Related Standards
GB/T 8446.3-2004
Heat sink for power semiconductor device--Part 3:Insulators and fasteners
GB/T 8446.2-2004
Heat sink for power semiconductor device--Part 2:Measuring method of thermal resistance and inputfluid-output fluid pressure difference
GB/T 8446.1-2004
Heat sink for power semiconductor device--Part 1:Casting kind series
GB/T 13151-2005
Semiconductor devices Discrete devices Part 6:Thyristors Section Three-Blank detail specification for reverse blocking triode thyristors,ambient and case-rated,for currents greater than 100A
GB/T 13150-2005
Semiconductor devices Discret devices Blank detail specification for bidirectional triode thyristors(triacs),ambient and case-rated,for currents greater than 100A
GB/Z 107-2025
Semiconductor devices—Scan based ageing level estimation for semiconductor devices
GB/Z 102.17-2026
Semiconductor devices—Discrete devices—Part 17: Magnetic and capacitive coupler for basic and reinforced insulation
GB/T 6589-2002
Semiconductordevices--Discrete devices--Part 3-2:Signal (including switching) and regulator diodes--Blank detail specification for voltage-regulator diodes and voltage-reference diodes (excluding temperature-compensated precision reference diodes)
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.