GB/T 13866-1992
ActiveShock and vibration measurements--Characteristics to be specified for seismic pick-ups
振动与冲击测量 描述惯性式传感器特性的规定
Application Summary AI generated
This standard specifies the characteristics that must be defined for seismic pick-ups (inertial sensors) used in shock and vibration measurements. It is applied in metrology and testing contexts to ensure consistent sensor specifications for applications such as structural health monitoring, machinery diagnostics, and environmental vibration testing. The standard provides a framework for describing sensor sensitivity, frequency response, and dynamic range, facilitating accurate data comparison across different measurement systems.
Related Standards
GB/T 20485.12-2008
Method for the calibration of vibration and shock transducers - Part 12: Primary vibration calibration by the reciprocity method
GB/T 13823.1-2005
Methods for the calibration of vibration and shock transducers part 1:Basic concepts
GB/T 14412-2005
Mechanical vibration and shock-Mechanical mounting of accelerometers
GB/T 6075.6-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 6:Reciprocating machines with power ratings above 100kW
GB/T 6075.5-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 5:Machine sets in hydraulic power generating and pumping plants
GB/T 6075.2-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 2:Large land-based steam turbine generator setsin excess of 50MW
GB/T 6075.4-2001
Mechanical vibration--Evaluation of machine vibration by measurementson non-rotating parts--Part 4:Gas turbine driven sets excluding aircraft derivatives
GB/T 6075.3-2001
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 3:Industrial machines with nominal power above 15kW and nominal speeds between 120r/min and 15000r/min when measured in situ
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.