GB/T 13823.19-2008
AbolishedMethods for the calibration of vibration and shock pick-ups - Calibration by Earth's gravitation
振动与冲击传感器的校准方法 地球重力法校准
Application Summary AI generated
This standard specifies a calibration method for vibration and shock pick-ups (accelerometers) using Earth's gravitation as a reference acceleration. It is applied in metrology laboratories and testing facilities to calibrate low-frequency accelerometers, typically in the range of 0.1 Hz to a few Hz, by comparing the sensor's output to the known gravitational acceleration (1 g). This method is particularly useful for field calibration or when precise shaker-based calibration equipment is unavailable.
Related Standards
GB/T 20485.12-2008
Method for the calibration of vibration and shock transducers - Part 12: Primary vibration calibration by the reciprocity method
GB/T 13823.1-2005
Methods for the calibration of vibration and shock transducers part 1:Basic concepts
GB/T 14412-2005
Mechanical vibration and shock-Mechanical mounting of accelerometers
GB/T 6075.6-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 6:Reciprocating machines with power ratings above 100kW
GB/T 6075.5-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 5:Machine sets in hydraulic power generating and pumping plants
GB/T 6075.2-2002
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 2:Large land-based steam turbine generator setsin excess of 50MW
GB/T 6075.4-2001
Mechanical vibration--Evaluation of machine vibration by measurementson non-rotating parts--Part 4:Gas turbine driven sets excluding aircraft derivatives
GB/T 6075.3-2001
Mechanical vibration--Evaluation of machine vibration by measurements on non-rotating parts--Part 3:Industrial machines with nominal power above 15kW and nominal speeds between 120r/min and 15000r/min when measured in situ
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.