GB 4793.2-2001
AbolishedSafety requirements for electrical equipment for measurement，control and laboratory use--Particular requirements for hand-held current clamp for electrical measurement and test
测量、控制及实验室用电气设备的安全 电工测量和试验用手持电流钳的特殊要求
Application Summary AI generated
This standard specifies particular safety requirements for hand-held current clamps used in electrical measurement and testing. It applies to equipment designed for non-contact current measurement in industrial, laboratory, and field environments, ensuring operator protection against electrical shock and mechanical hazards. The standard is used in conjunction with the general safety requirements of GB 4793.1 for compliance testing and certification of these devices.
Related Standards
GB/T 7354-2003
Partial discharge measurements
GB/T 311.6-2005
Voltage measurement by means of standard air gaps
GB/T 18134.1-2000
High-voltage testing techniques with very fast impulses--Part 1:Measuring systems for very fast front overvoltages generated in gas-insulated substations
GB/T 16511-1996
Electrical and electronic measuring equipment--Documentation
GB/T 14537-1993
Shock and bump tests on measuringrelays and protection equipment
GB/T 7265.2-1987
Test method for the complex permittivity of solid dielectric materials at microwave frequencies--Open cavity method
GB/T 7265.1-1987
Test method for complex permittivity of solid dielectric materials at microwave frequencies--Perturbation method
GB/T 3929-1983
Standard cells
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.