GB/T 9575-2013
ActiveRubber and plastics hoses - Hose sizes, minimum and maximum inside diameters, and tolerances on cut-to-length hoses
橡胶和塑料软管 软管规格和最大最小内径及切割长度公差
Application Summary AI generated
This standard specifies the dimensional requirements for rubber and plastics hoses, including nominal sizes, minimum and maximum inside diameters, and tolerances for cut-to-length hoses. It is applied in the design, manufacturing, and quality inspection of hoses used in fluid systems, such as hydraulic, pneumatic, and industrial transfer applications, ensuring compatibility with fittings and consistent performance.
Related Standards
GB/T 5566-2003
Rubber or plastics hoses--Test method for crush resistance
GB/T 15345-2003
Test methods of concrete pipes for water transmission
GB/T 19278-2003
General terms and their definitions of thermoplastic pipes，fittings and valves
GB/T 19279-2003
Polyethylene pipes--Resistance to slow crack growth--Cone test method
GB/T 19280-2003
Thermoplastics pipes for the conveyance of fluids--Determination of resistance to rapid crack propagation (RCP)--Small-scale steady-state test(S4 test)
GB/T 19293-2003
Method of X-ray radioscopy for butt-weld
GB/T 6071-2003
Ultra-high vacuum flange
GB/T 9128-2003
Dimensions of metallic ring-joint gaskets for use with steel pipe flanges
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.