GB/T 8803-2001

Active

Injection-moulded unplasticized poly(vinyl chloride)(PVC-U)，chlorinated poly(vinyl chloride)(PVC-C)，acrylonitrile butadiene-styrene(ABS)and acrylonitrile-styrene-acrylester(ASA)fittings--Hot oven test method

注射成型硬质聚氯乙烯(PVC-U)、氯化聚氯乙烯(PVC-C)、丙烯腈-丁二烯-苯乙烯三元共聚物(ABS)和丙烯腈-苯乙烯-丙烯酸盐三元共聚物(ASA)管件热烘箱试验方法

Standard Type

GBT

ICS

23.040.20

CCS

G33

Status

Active

Issue Date

2001-10-24

Implementation

2002-05-01

Centralized Committee

中国轻工业联合会

Issuing Authority

中华人民共和国国家质量监督检验检疫总局

Application Summary AI generated

This standard specifies a hot oven test method for injection-moulded fittings made from PVC-U, PVC-C, ABS, and ASA. It is applied in the quality control and testing of plastic pipe fittings used in fluid transport systems, such as water supply, drainage, and industrial piping, to assess their thermal stability and resistance to deformation under elevated temperatures.

Related Standards

GB/T 5566-2003 Rubber or plastics hoses--Test method for crush resistance GB/T 15345-2003 Test methods of concrete pipes for water transmission GB/T 19278-2003 General terms and their definitions of thermoplastic pipes，fittings and valves GB/T 19279-2003 Polyethylene pipes--Resistance to slow crack growth--Cone test method GB/T 19280-2003 Thermoplastics pipes for the conveyance of fluids--Determination of resistance to rapid crack propagation (RCP)--Small-scale steady-state test(S4 test) GB/T 19293-2003 Method of X-ray radioscopy for butt-weld GB/T 6071-2003 Ultra-high vacuum flange GB/T 9128-2003 Dimensions of metallic ring-joint gaskets for use with steel pipe flanges

Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.