GB/T 6403.5-2008

Active

Relief grooves for grinding wheels

砂轮越程槽

Standard Type
GBT
ICS
25.010
CCS
J05
Status
Active
Issue Date
2008-09-27
Implementation
2009-05-01
Centralized Committee
国家标准委
Issuing Authority
中华人民共和国国家质量监督检验检疫总局、中国国家标准化管理委员会

Application Summary AI generated

GB/T 6403.5-2008 specifies the dimensions, tolerances, and design requirements for relief grooves used on grinding wheels. It is applied in mechanical manufacturing and precision machining contexts to prevent interference between the grinding wheel and workpiece during grinding operations, ensuring safe and accurate material removal. The standard is primarily used by engineers and machinists in industries such as automotive, aerospace, and tooling for designing and inspecting grinding wheel setups.

Related Standards

GB/T 15826.1-1995 Machining allowances and tolerances for steel open die forgings on hammer--General requirement GB/T 15826.9-1995 Machining allowances and tolerances for steel open die forgings on hammer--Forging without machining GB/T 15826.8-1995 Machining allowances and tolerances for steel open die forgings on hammer--Single throw crankshaft GB/T 15826.7-1995 Machining allowances and tolerances for steel open die forgings on hammer--Shaft with steps GB/T 15826.4-1995 Machining allowances and tolerances for steel open die forgings on hammer--Rings GB/T 15826.6-1995 Machining allowances and tolerances for steel open die forgings on hammer--Shaft without steps GB/T 15826.3-1995 Machining allowances and tolerances for steel open die forgings on hammer--Disk swith holes GB/T 15826.5-1995 Machining allowances and tolerances for steel open die forgings on hammer--Seamles cylinder hushings
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.