GB/T 15826.7-1995
AbolishedMachining allowances and tolerances for steel open die forgings on hammer--Shaft with steps
锤上钢质自由锻件机械加工余量与公差 台阶轴类
Application Summary AI generated
This standard specifies the machining allowances and tolerances for steel open die forgings shaped as stepped shafts produced on hammers. It is applied in the manufacturing industry to guide the design and production of rough forgings, ensuring sufficient material for subsequent machining while maintaining dimensional accuracy. The standard is particularly relevant for mechanical engineering and heavy equipment sectors where stepped shafts are common components.
Related Standards
GB/T 15826.1-1995
Machining allowances and tolerances for steel open die forgings on hammer--General requirement
GB/T 15826.9-1995
Machining allowances and tolerances for steel open die forgings on hammer--Forging without machining
GB/T 15826.8-1995
Machining allowances and tolerances for steel open die forgings on hammer--Single throw crankshaft
GB/T 15826.4-1995
Machining allowances and tolerances for steel open die forgings on hammer--Rings
GB/T 15826.6-1995
Machining allowances and tolerances for steel open die forgings on hammer--Shaft without steps
GB/T 15826.3-1995
Machining allowances and tolerances for steel open die forgings on hammer--Disk swith holes
GB/T 15826.5-1995
Machining allowances and tolerances for steel open die forgings on hammer--Seamles cylinder hushings
GB/T 15826.2-1995
Machining allowances and tolerances for steel open die forgings on hammer--Disks and columns
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.