GB/T 6110-1985
AbolishedHardmetal dies for drawing wires and bars--Types and dimensions
硬质合金拉制模具 型式和尺寸
Application Summary AI generated
This standard specifies the types and dimensions of hardmetal dies used for drawing wires and bars. It is applied in the manufacturing industry, particularly in metalworking processes where wire and bar stock are reduced in diameter through cold drawing. The standard ensures interchangeability and consistency in die design for production and quality control.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.