GB/T 34374-2017
ActiveStamping dies—L-shaped guide plates
冲模 L形导板
Application Summary AI generated
GB/T 34374-2017 specifies the dimensions, technical requirements, and marking for L-shaped guide plates used in stamping dies. It applies to the design and manufacturing of press tooling in the metalworking industry, ensuring precise alignment and smooth sliding motion between die components during stamping operations. This standard is critical for quality control and interchangeability in die sets for automotive, electronics, and general sheet metal forming.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
GB/T 4678.3-2003
Die-casting die components--Part 3: Rectangular insert block
GB/T 4678.4-2003
Die-casting die components--Part 4: Shouldered guide pillar
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.