GB/T 31210.2-2014
ActiveGreen manufacturing—Near dry cutting—Part 2: Technical requirements for minimum quantity lubricating system
绿色制造 亚干式切削 第2部分：微量润滑系统技术要求
Application Summary AI generated
This standard specifies the technical requirements for minimum quantity lubricating (MQL) systems used in near-dry cutting processes, including system composition, performance parameters, and safety criteria. It is applied in the manufacturing industry, specifically for machine tools and machining operations where a minimal amount of lubricant is delivered to the cutting zone to reduce environmental impact and improve efficiency. The standard guides engineers and procurement professionals in selecting, testing, and verifying MQL systems for green manufacturing practices.
Related Standards
GB/T 15826.1-1995
Machining allowances and tolerances for steel open die forgings on hammer--General requirement
GB/T 15826.9-1995
Machining allowances and tolerances for steel open die forgings on hammer--Forging without machining
GB/T 15826.8-1995
Machining allowances and tolerances for steel open die forgings on hammer--Single throw crankshaft
GB/T 15826.7-1995
Machining allowances and tolerances for steel open die forgings on hammer--Shaft with steps
GB/T 15826.4-1995
Machining allowances and tolerances for steel open die forgings on hammer--Rings
GB/T 15826.6-1995
Machining allowances and tolerances for steel open die forgings on hammer--Shaft without steps
GB/T 15826.3-1995
Machining allowances and tolerances for steel open die forgings on hammer--Disk swith holes
GB/T 15826.5-1995
Machining allowances and tolerances for steel open die forgings on hammer--Seamles cylinder hushings
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.