GB/T 31210.1-2014
ActiveGreen manufacturing—Near dry cutting—Part 1: General requirements
绿色制造 亚干式切削 第1部分：通用技术要求
Application Summary AI generated
This standard specifies general technical requirements for near dry cutting processes, including minimum quantity lubrication (MQL) system specifications, cutting fluid selection, and process control parameters. It is applied in the mechanical manufacturing industry, particularly for machining operations such as turning, milling, and drilling where reducing coolant usage is desired. The standard guides manufacturers in implementing environmentally friendly cutting practices while maintaining machining quality and tool life.
Related Standards
GB/T 15826.1-1995
Machining allowances and tolerances for steel open die forgings on hammer--General requirement
GB/T 15826.9-1995
Machining allowances and tolerances for steel open die forgings on hammer--Forging without machining
GB/T 15826.8-1995
Machining allowances and tolerances for steel open die forgings on hammer--Single throw crankshaft
GB/T 15826.7-1995
Machining allowances and tolerances for steel open die forgings on hammer--Shaft with steps
GB/T 15826.4-1995
Machining allowances and tolerances for steel open die forgings on hammer--Rings
GB/T 15826.6-1995
Machining allowances and tolerances for steel open die forgings on hammer--Shaft without steps
GB/T 15826.3-1995
Machining allowances and tolerances for steel open die forgings on hammer--Disk swith holes
GB/T 15826.5-1995
Machining allowances and tolerances for steel open die forgings on hammer--Seamles cylinder hushings
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.