GB/T 30573-2014
ActiveFine blanked parts―General technical requirements
精密冲裁件 通用技术条件
Application Summary AI generated
This standard specifies the general technical requirements for fine blanked parts, including dimensional tolerances, surface quality, material specifications, and inspection methods. It is applied in the manufacturing industry for precision components produced by fine blanking processes, such as automotive transmission parts, office equipment mechanisms, and electronic device connectors. The standard ensures consistent quality and interchangeability of fine blanked parts across production and procurement contexts.
Related Standards
GB/T 15826.1-1995
Machining allowances and tolerances for steel open die forgings on hammer--General requirement
GB/T 15826.9-1995
Machining allowances and tolerances for steel open die forgings on hammer--Forging without machining
GB/T 15826.8-1995
Machining allowances and tolerances for steel open die forgings on hammer--Single throw crankshaft
GB/T 15826.7-1995
Machining allowances and tolerances for steel open die forgings on hammer--Shaft with steps
GB/T 15826.4-1995
Machining allowances and tolerances for steel open die forgings on hammer--Rings
GB/T 15826.6-1995
Machining allowances and tolerances for steel open die forgings on hammer--Shaft without steps
GB/T 15826.3-1995
Machining allowances and tolerances for steel open die forgings on hammer--Disk swith holes
GB/T 15826.5-1995
Machining allowances and tolerances for steel open die forgings on hammer--Seamles cylinder hushings
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.