GB/T 2861.10-2008
ActiveGuide unit for stamping dies - Part 10: Washers
冲模导向装置 第10部分：垫圈
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking of washers used in guide units for stamping dies. It is applied in the manufacturing of press tools and stamping dies to ensure proper spacing, load distribution, and alignment of guide components during metal forming operations. The standard is relevant for die makers, toolrooms, and quality control in the automotive, appliance, and general metalworking industries.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.