GB/T 2856.2-2008
ActiveHolders for ball-bearing die sets for stamping dies - Part 2: Die holders for die sets
冲模滚动导向模座 第2部分：下模座
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking of die holders used in the lower part of ball-bearing die sets for stamping dies. It is applied in the manufacturing of precision stamping dies, particularly in industries such as automotive, electronics, and appliance production, where consistent alignment and reduced friction in high-volume stamping operations are critical. The standard ensures interchangeability and compatibility of die holders with corresponding guide components in die set assemblies.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.