GB/T 2855.2-2008
ActiveHolders for sliding guide die sets for stamping dies - Part 2: Die holders for die sets
冲模滑动导向模座 第2部分：下模座
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking of lower die holders used in sliding guide die sets for stamping dies. It is applied in the manufacturing of stamping dies for metal forming processes, ensuring interchangeability and precision in die assembly. The standard is relevant for tool and die makers, press shops, and quality control in industries such as automotive, electronics, and appliance production.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.