GB/T 2855.1-2008
ActiveHolders for sliding guide die sets for stamping dies - Part 1: Punch holders for die sets
冲模滑动导向模座 第1部分：上模座
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking of punch holders used in sliding guide die sets for stamping dies. It is applied in the manufacturing of metal stamping tools, particularly for press operations requiring precise alignment and sliding motion between the upper and lower die halves. The standard ensures interchangeability and quality consistency for punch holders used in industrial stamping processes, such as automotive or electronics component production.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.