GB/T 24736.1-2009

Active

Management guide for tooling design - Part 1: Vocabulary

工艺装备设计管理导则 第1部分：术语

Standard Type
GBT
ICS
25.010
CCS
J04
Status
Active
Issue Date
2009-11-30
Implementation
2010-09-01
Centralized Committee
国家标准委
Issuing Authority
中华人民共和国国家质量监督检验检疫总局、中国国家标准化管理委员会

Application Summary AI generated

This standard defines the key terminology used in the management of tooling design, covering terms for jigs, fixtures, molds, and other production aids. It is applied in Chinese manufacturing industries, particularly in mechanical engineering and production planning, to ensure consistent communication and documentation across design, procurement, and quality control teams.

Related Standards

GB/T 15826.1-1995 Machining allowances and tolerances for steel open die forgings on hammer--General requirement GB/T 15826.9-1995 Machining allowances and tolerances for steel open die forgings on hammer--Forging without machining GB/T 15826.8-1995 Machining allowances and tolerances for steel open die forgings on hammer--Single throw crankshaft GB/T 15826.7-1995 Machining allowances and tolerances for steel open die forgings on hammer--Shaft with steps GB/T 15826.4-1995 Machining allowances and tolerances for steel open die forgings on hammer--Rings GB/T 15826.6-1995 Machining allowances and tolerances for steel open die forgings on hammer--Shaft without steps GB/T 15826.3-1995 Machining allowances and tolerances for steel open die forgings on hammer--Disk swith holes GB/T 15826.5-1995 Machining allowances and tolerances for steel open die forgings on hammer--Seamles cylinder hushings
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.