GB/T 23566.1-2009
ActiveSliding guide steel-plate punch holders of stamping dies - Part 1: Rear-pillar punch holders
冲模滑动导向钢板上模座 第1部分：后侧导柱上模座
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking for rear-pillar punch holders used in stamping dies with sliding guide steel plates. It is applied in the manufacturing of stamping dies for sheet metal forming, ensuring interchangeability and precision in die assembly for press machines. The standard is primarily used by die makers and manufacturers in the automotive, electronics, and general metalworking industries.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.