GB/T 23565.4-2009
ActiveSliding guide steel-plate die sets of stamping dies - Part 4: Four-pillar die sets
冲模滑动导向钢板模架 第4部分：四导柱模架
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking methods for four-pillar sliding guide steel-plate die sets used in stamping dies. It is applied in the manufacturing of precision stamping dies, particularly for high-speed or large-scale production where enhanced stability and alignment are required. The standard ensures interchangeability and quality consistency for die sets in industries such as automotive, electronics, and appliance manufacturing.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.3-2003
Die-casting die components--Part 3: Rectangular insert block
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.