GB/T 23565.2-2009
ActiveSliding guide steel-plate die sets of stamping dies - Part 2: Diagonal-pillar die sets
冲模滑动导向钢板模架 第2部分：对角导柱模架
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking methods for diagonal-pillar die sets used in sliding guide steel-plate die sets for stamping dies. It is applied in the manufacturing of precision stamping dies, particularly in industries like automotive, electronics, and appliance production, where diagonal guide pillars ensure accurate alignment and smooth operation during high-volume stamping processes. The standard is used by die makers and quality inspectors to verify interchangeability and performance consistency of these die sets.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.