GB/T 23562.1-2009
ActiveSteel-plate die holders of stamping dies - Part 1: Rear-pillar die holders
冲模钢板下模座 第1部分：后侧导柱下模座
Application Summary AI generated
This standard specifies the dimensions, technical requirements, and marking for rear-pillar steel-plate die holders used in stamping dies. It is applied in the manufacturing of press tools for sheet metal forming, ensuring interchangeability and precision in die sets for industries such as automotive, electronics, and appliance production. The standard is particularly relevant for die makers and stamping workshops that require standardized lower die holders with rear guide pillar configurations.
Related Standards
GB/T 10924-2009
Straight sided single or two-point mechanical power presses - Testing of the accuracy
GB/T 4678.8-2003
Die-casting die components--Part 8: Ejectorplate
GB/T 4678.9-2003
Die-casting die components--Part 9: Ejector guide pillar
GB/T 4678.16-2003
Die-casting die components--Part 16: Flat ejector pin
GB/T 4678.17-2003
Die-casting die components--Part 17: Ejector sleeve
GB/T 4678.18-2003
Die-casting die components--Part 18: Support pillar
GB/T 4678.19-2003
Die-casting die components--Part 19: Locating element
GB/T 4678.2-2003
Die-casting die components--Part 2: Round insert block
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.