GB/T 18042-2000
ActiveThermoplastics pipes--Determination of creep ratio
热塑性塑料管材蠕变比率的试验方法
Application Summary AI generated
This standard specifies a test method for determining the creep ratio of thermoplastics pipes under constant internal pressure at a specified temperature. It is applied in the quality control and design verification of plastic piping systems used for fluid transport, such as water supply, drainage, and industrial pipelines, to assess long-term deformation behavior under sustained load.
Related Standards
GB/T 5566-2003
Rubber or plastics hoses--Test method for crush resistance
GB/T 15345-2003
Test methods of concrete pipes for water transmission
GB/T 19278-2003
General terms and their definitions of thermoplastic pipes，fittings and valves
GB/T 19279-2003
Polyethylene pipes--Resistance to slow crack growth--Cone test method
GB/T 19280-2003
Thermoplastics pipes for the conveyance of fluids--Determination of resistance to rapid crack propagation (RCP)--Small-scale steady-state test(S4 test)
GB/T 19293-2003
Method of X-ray radioscopy for butt-weld
GB/T 6071-2003
Ultra-high vacuum flange
GB/T 9128-2003
Dimensions of metallic ring-joint gaskets for use with steel pipe flanges
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.