GB/T 15820-1995
ActiveTest of resistance to pull out ofjoints between polyethylene (PE) pressure pipes and fittings
聚乙烯压力管材与管件连接的耐拉拔试验
Application Summary AI generated
This standard specifies a test method for evaluating the resistance to axial pull-out forces at joints between polyethylene (PE) pressure pipes and fittings. It is applied in the quality control and performance verification of PE piping systems used for water supply, gas distribution, and other pressurized fluid transport. The test ensures joint integrity under tensile stress, preventing disconnection during installation or service.
Related Standards
GB/T 5566-2003
Rubber or plastics hoses--Test method for crush resistance
GB/T 15345-2003
Test methods of concrete pipes for water transmission
GB/T 19278-2003
General terms and their definitions of thermoplastic pipes，fittings and valves
GB/T 19280-2003
Thermoplastics pipes for the conveyance of fluids--Determination of resistance to rapid crack propagation (RCP)--Small-scale steady-state test(S4 test)
GB/T 19279-2003
Polyethylene pipes--Resistance to slow crack growth--Cone test method
GB/T 19293-2003
Method of X-ray radioscopy for butt-weld
GB/T 6071-2003
Ultra-high vacuum flange
GB/T 9128-2003
Dimensions of metallic ring-joint gaskets for use with steel pipe flanges
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.