GB/T 13018-1991
AbolishedPolyethylene (PE) pipes--Toleranceson outside diameters and wall thicknesses
聚乙烯(PE)管材 外径和壁厚极限偏差
Application Summary AI generated
This standard specifies the permissible tolerances for the outside diameters and wall thicknesses of polyethylene (PE) pipes. It is applied in the manufacturing and quality inspection of PE pipes used in fluid transport systems, such as water supply, drainage, and irrigation. The standard ensures dimensional consistency and interchangeability for piping components in engineering and procurement contexts.
Related Standards
GB/T 5566-2003
Rubber or plastics hoses--Test method for crush resistance
GB/T 15345-2003
Test methods of concrete pipes for water transmission
GB/T 19278-2003
General terms and their definitions of thermoplastic pipes，fittings and valves
GB/T 19280-2003
Thermoplastics pipes for the conveyance of fluids--Determination of resistance to rapid crack propagation (RCP)--Small-scale steady-state test(S4 test)
GB/T 19279-2003
Polyethylene pipes--Resistance to slow crack growth--Cone test method
GB/T 19293-2003
Method of X-ray radioscopy for butt-weld
GB/T 6071-2003
Ultra-high vacuum flange
GB/T 9128-2003
Dimensions of metallic ring-joint gaskets for use with steel pipe flanges
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.