GB/T 12385-2008
AbolishedStandard test method for sealability of gaskets for pipe flanges
管法兰用垫片密封性能试验方法
Application Summary AI generated
This standard specifies a test method for evaluating the sealing performance of gaskets used between pipe flanges. It is applied in industrial fluid systems, such as chemical, petrochemical, and power generation plants, to measure a gasket's ability to prevent leakage under specified pressure and temperature conditions. The method is critical for quality control and material selection in piping systems that handle gases or liquids.
Related Standards
GB/T 5566-2003
Rubber or plastics hoses--Test method for crush resistance
GB/T 15345-2003
Test methods of concrete pipes for water transmission
GB/T 19278-2003
General terms and their definitions of thermoplastic pipes，fittings and valves
GB/T 19280-2003
Thermoplastics pipes for the conveyance of fluids--Determination of resistance to rapid crack propagation (RCP)--Small-scale steady-state test(S4 test)
GB/T 19279-2003
Polyethylene pipes--Resistance to slow crack growth--Cone test method
GB/T 19293-2003
Method of X-ray radioscopy for butt-weld
GB/T 6071-2003
Ultra-high vacuum flange
GB/T 9128-2003
Dimensions of metallic ring-joint gaskets for use with steel pipe flanges
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.