GB/Z 6113.205-2013
ActiveSpecification for radio disturbance and immunity measuring apparatus and methods―Part 2-5: In situ measurements of disturbing emissions produced by physically large equipment
无线电骚扰和抗扰度测量设备和测量方法规范 第2-5部分：大型设备骚扰发射现场测量
Application Summary AI generated
This standard specifies methods for measuring radio disturbance emissions from physically large equipment, such as industrial machinery or power installations, directly at their installation site rather than in a test laboratory. It is applied in the telecommunications and electromagnetic compatibility (EMC) field to assess compliance with emission limits for equipment that cannot be tested in standard shielded rooms due to size or operational constraints. The standard ensures accurate in situ measurement procedures for regulatory and interference mitigation purposes.
Related Standards
GB/T 17626.17-2005
Electromagnetic compatibility Testing and measurement techniques Ripple on d.c.input power port immunity test
GB/T 17626.14-2005
Electromagnetic compatibility Testing and measurement techniques Voltage fluctuation immunity test
GB/Z 17625.3-2000
Electromagnetic compatibility--Limits--Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16 A
GB/Z 17625.5-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for fluctuating loads in MV and HV power systems
GB/Z 18039.2-2000
Electromagneticcompatibility -- Environment --Assessment of the emission levels in the power supply of industrial plants as regards low-frequency conducted disturbances
GB/Z 17625.4-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for distorting loadsin MV and HV power systems
GB/Z 18039.5-2003
Electromagnetic compatibility--Environment--Electromagnetic environment for low-frequency conducted disturbances and signalling in public power supply systems
GB/Z 17625.6-2003
Electromagnetic compatibility--Limits--Limitation of emission of harmonic currents in low-voltage power supply systems for equipment with rated current greater than 16A
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.