GB/T 9771.2-2000
AbolishedThe series of single-mode optical fibres for telecommunication--Part 2:Characteristics of a cut-off wavelength shifted single-mode optical fibre
通信用单模光纤系列 第2部分:截止波长位移单模光纤特性
Application Summary AI generated
GB/T 9771.2-2000 specifies the geometric, optical, transmission, and mechanical characteristics of cut-off wavelength shifted single-mode optical fibres used in telecommunications. It applies to fibres designed for long-haul, high-bit-rate transmission systems operating in the 1550 nm wavelength window, where shifting the cut-off wavelength reduces bending losses. This standard is used by fibre manufacturers and network operators to ensure consistent performance in dense wavelength division multiplexing (DWDM) and submarine cable applications.
Related Standards
GB/T 18311.34-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-34:Examinations and measurements--Attenuation of random mated connectors
GB/T 18311.4-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-4:Examinations and measurements--Attenuation
GB/T 18311.40-2003
Fibre optic interconnecting devices and passivecomponents--Basic test and measurement procedures--Part 3-40:Examinations and measurements--Extinction ratio of a polarization maintaining(pm)fibre pigtailed connector
GB/T 18311.5-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-5:Examinations and measurements--Wavelength dependence of attenuation
GB/T 7424.4-2003
Optical fiber cables--Part 4-1:Section specification--Optical fibre composite overhead ground wire
GB/T 18311.1-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-1:Examinations and measurements--Visual examination
GB/T 7424.1-2003
Generic specification for optical fibre cables--Part 1:General
GB/T 18310.26-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 2-26:Tests--Salt mist
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.