GB/T 892-1986
ActiveLock rings at the end of shaft with bolt
螺栓紧固轴端挡圈
Application Summary AI generated
GB/T 892-1986 specifies the dimensions, material, and technical requirements for lock rings used to secure components at the end of a shaft using bolts. It is applied in mechanical assemblies, such as gearboxes, motors, and industrial machinery, where axial retention of parts like pulleys or bearings on shaft ends is required. The standard ensures reliable fastening under dynamic loads in manufacturing and maintenance contexts.
Related Standards
GB/T 62.3-2004
Wing nuts--Pressing wing
GB/T 9074.20-2004
Cross recessed hexagon head tapping screw with indentation and washer assemblies with plain washers
GB/T 62.1-2004
Wing nuts--Round wing
GB/T 9074.5-2004
Cross recessed small pan head screw andwasher assemblies with plain washers
GB/T 62.2-2004
Wing nuts--Square wing
GB/T 62.4-2004
Wing nuts--Die-casting wing
GB/T 3098.20-2004
Mechanical properties of fasteners--Wing nuts with specified proof torque
GB/T 3098.19-2004
Mechanical properties of fasteners--Blind rivets with break pull mandrel
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.