GB/T 7017-1986

Active

Method of measurement of non-linearity in resistors

电阻器非线性测量方法

Standard Type
GBT
ICS
31.040
CCS
L13
Status
Active
Issue Date
1986-11-20
Implementation
1987-09-01
Centralized Committee
工业和信息化部（电子）
Issuing Authority
国家标准局

Application Summary AI generated

This standard specifies the test methods for measuring the non-linearity (third harmonic distortion) in fixed resistors, primarily used for quality assessment and screening in the electronics industry. It is applied during the manufacturing and incoming inspection of resistors for audio, communication, and precision analog circuits, where linearity is critical to signal integrity. The standard provides a consistent testing framework to ensure resistors meet performance requirements in low-distortion applications.

Related Standards

GB/T 5729-2003 Fixed resistors for use in electronic equipment--Part 1:Generic specification GB/T 7154.4-2003 Thermistors--Directly heated positive step-function temperature coefficient--Part 1-4: Blank detail specification--Sensing application--Assessment level EZ GB/T 7154.3-2003 Thermistors--Directly heated positive step-function temperature coefficient--Part 1-3: Blank detail specification--Inrush current application--Assessment level EZ GB/T 7154.2-2003 Thermistors--Directly heated positive step-function temperature coefficient--Part 1-2: Blank detail specification--Heating element application--Assessment level EZ GB/T 7154.1-2003 Thermistors--Directly heated positive step-function temperature coefficient--Part 1-1:Blank detail specification for current limiting application--Assessment level EZ GB/T 18806-2002 General specification for the resistance strain pressure transducer/sensor GB/T 7153-2002 Directly heated positive step-function temperature coefficient thermistors--Part 1:Generic specification GB/T 10194-1997 Varistors for use in electronic equipment--Part 2:Sectional specification for surge suppression varistors
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.