GB/T 6113.201-2017
AbolishedSpecification for radio disturbance and immunity measuring apparatus and methods—Part 2-1: Methods of measurement of disturbances and immunity—Conducted disturbance measurements
无线电骚扰和抗扰度测量设备和测量方法规范 第2-1 部分：无线电骚扰和抗扰度测量方法 传导骚扰测量
Application Summary AI generated
This standard specifies the methods for measuring conducted electromagnetic disturbances on power and signal lines, covering frequencies from 9 kHz to 30 MHz. It is applied in EMC testing laboratories and by manufacturers to evaluate the conducted emissions of electrical and electronic equipment, ensuring compliance with regulatory limits for radio disturbance. The standard is essential for products such as household appliances, industrial equipment, and information technology devices that must meet national electromagnetic compatibility requirements.
Related Standards
GB/T 17626.17-2005
Electromagnetic compatibility Testing and measurement techniques Ripple on d.c.input power port immunity test
GB/T 17626.14-2005
Electromagnetic compatibility Testing and measurement techniques Voltage fluctuation immunity test
GB/Z 17625.3-2000
Electromagnetic compatibility--Limits--Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16 A
GB/Z 17625.4-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for distorting loadsin MV and HV power systems
GB/Z 17625.5-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for fluctuating loads in MV and HV power systems
GB/Z 18039.2-2000
Electromagneticcompatibility -- Environment --Assessment of the emission levels in the power supply of industrial plants as regards low-frequency conducted disturbances
GB/Z 18039.5-2003
Electromagnetic compatibility--Environment--Electromagnetic environment for low-frequency conducted disturbances and signalling in public power supply systems
GB/Z 17625.6-2003
Electromagnetic compatibility--Limits--Limitation of emission of harmonic currents in low-voltage power supply systems for equipment with rated current greater than 16A
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.