GB/T 6113.105-2018
ActiveSpecification for radio disturbance and immunity measuring apparatus and methods—Part 1-5:Radio disturbance and immunity measuring apparatus—Antenna calibration sites and reference test sites for 5 MHz to 18 GHz
无线电骚扰和抗扰度测量设备和测量方法规范 第1-5部分：无线电骚扰和抗扰度测量设备 5MHz～18GHz天线校准场地和参考试验场地
Application Summary AI generated
This standard specifies the requirements for antenna calibration sites and reference test sites used in electromagnetic compatibility (EMC) testing for frequencies from 5 MHz to 18 GHz. It is applied by testing laboratories and manufacturers to ensure accurate and repeatable measurements of radio disturbance and immunity for electronic and electrical products. The standard is critical for validating the performance of antennas and test environments in industries such as telecommunications, automotive, and consumer electronics.
Related Standards
GB/T 17626.17-2005
Electromagnetic compatibility Testing and measurement techniques Ripple on d.c.input power port immunity test
GB/T 17626.14-2005
Electromagnetic compatibility Testing and measurement techniques Voltage fluctuation immunity test
GB/Z 17625.5-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for fluctuating loads in MV and HV power systems
GB/Z 17625.4-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for distorting loadsin MV and HV power systems
GB/Z 18039.2-2000
Electromagneticcompatibility -- Environment --Assessment of the emission levels in the power supply of industrial plants as regards low-frequency conducted disturbances
GB/Z 17625.3-2000
Electromagnetic compatibility--Limits--Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16 A
GB/Z 17625.6-2003
Electromagnetic compatibility--Limits--Limitation of emission of harmonic currents in low-voltage power supply systems for equipment with rated current greater than 16A
GB/Z 18039.5-2003
Electromagnetic compatibility--Environment--Electromagnetic environment for low-frequency conducted disturbances and signalling in public power supply systems
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.