GB/T 6113.103-2008
AbolishedSpecification for radio disturbance and immunity measuring apparatus and methods - Part 1-3: Radio disturbance and immunity measuring apparatus-Ancillary equipment - Disturbances power
无线电骚扰和抗扰度测量设备和测量方法规范 第1-3部分: 无线电骚扰和抗扰度测量设备 辅助设备 骚扰功率
Application Summary AI generated
This standard specifies the requirements for ancillary equipment used to measure disturbance power in the frequency range of 30 MHz to 1 GHz. It is applied in electromagnetic compatibility (EMC) testing for electrical and electronic products, ensuring that measuring apparatus like absorbing clamps meet performance criteria for accurate radio disturbance power measurements.
Related Standards
GB/T 17626.17-2005
Electromagnetic compatibility Testing and measurement techniques Ripple on d.c.input power port immunity test
GB/T 17626.14-2005
Electromagnetic compatibility Testing and measurement techniques Voltage fluctuation immunity test
GB/Z 17625.4-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for distorting loadsin MV and HV power systems
GB/Z 17625.5-2000
Electromagnetic compatibility--Limits--Assessment of emission limits for fluctuating loads in MV and HV power systems
GB/Z 18039.2-2000
Electromagneticcompatibility -- Environment --Assessment of the emission levels in the power supply of industrial plants as regards low-frequency conducted disturbances
GB/Z 17625.3-2000
Electromagnetic compatibility--Limits--Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16 A
GB/Z 17625.6-2003
Electromagnetic compatibility--Limits--Limitation of emission of harmonic currents in low-voltage power supply systems for equipment with rated current greater than 16A
GB/Z 18039.5-2003
Electromagnetic compatibility--Environment--Electromagnetic environment for low-frequency conducted disturbances and signalling in public power supply systems
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.