GB/T 5095.5-1997
ActiveElectromechanical components for electronic equipment--Basic testing procedures and measuring methods--Part 5:Impact tests(free components)，static load tests(fixed components)，endurance tests and overload tests
电子设备用机电元件 基本试验规程及测量方法 第5部分:撞击试验(自由元件)、静负荷试验(固定元件)、寿命试验和过负荷试验
Application Summary AI generated
This standard specifies testing procedures for electromechanical components used in electronic equipment, covering impact tests for free components, static load tests for fixed components, endurance tests, and overload tests. It is applied in the design, manufacturing, and quality verification of connectors, switches, and similar components to ensure mechanical robustness and operational reliability under stress. The standard is relevant for industries producing consumer electronics, telecommunications equipment, and industrial control systems where component durability is critical.
Related Standards
GB/T 18496.2-2005
Electromechanical switches for use in electronic equipment Part 4-1:Sectional specification for lever(toggle)switches Blank detail specification
GB/T 17562.8-2002
Rectangular connectors for frequencies below 3MHz--Part 8:Detail specification for connectors，four-signal contacts and earthing contacts for cable screen
GB/T 15157.7-2002
Connectors for frequencies below 3MHz for use with printed boards--Part 7:Detail specification for connectors，8-way，including fixed and free connectors with common mating features，with assessed quality
GB/T 18501.2-2001
Connectors for use in d.c.，low-frequency analogue and digital high speed data spplications--Part 2:Circular connectors with assessed quality--Sectional specification
GB/T 18501.1-2001
Connectors with assessed quality，for use in d.c.，low frequency analogue and in digital high speed data applications--Part 1:Generic specification
GB/T 18496-2001
Electromechanical switches for use in electronic equipment--Part 4:Sectional specification for lever(toggle) switches
GB/T 17562.1-1998
Rectangular connectors for frequencies below 3 MHz--Part 1: Generic specification--General requirements and guide for the preparation of detail specifications for connectors with assessed quality
GB/T 13420-1998
Electromechanical switches for use in electronic equipment--Part 6:Sectional specification for sensitive switches--Section 1:Blank detail specification
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.