GB/T 5095.2501-2021
ActiveElectromechanical components for electronic equipment—Basic testing procedures and measuring methods—Part 25-1: Test 25a: Crosstalk ratio
电子设备用机电元件 基本试验规程及测量方法 第25-1部分：试验25a：串扰比
Application Summary AI generated
This standard defines a specific test method (Test 25a) for measuring the crosstalk ratio in electromechanical components used in electronic equipment. It is applied during the design validation and quality assurance of connectors, sockets, and similar components to ensure signal integrity in high-frequency data transmission systems. The standard is particularly relevant for telecommunications, computing, and industrial electronics where minimizing electromagnetic interference between adjacent circuits is critical.
Related Standards
GB/T 18496.2-2005
Electromechanical switches for use in electronic equipment Part 4-1:Sectional specification for lever(toggle)switches Blank detail specification
GB/T 17562.8-2002
Rectangular connectors for frequencies below 3MHz--Part 8:Detail specification for connectors，four-signal contacts and earthing contacts for cable screen
GB/T 15157.7-2002
Connectors for frequencies below 3MHz for use with printed boards--Part 7:Detail specification for connectors，8-way，including fixed and free connectors with common mating features，with assessed quality
GB/T 18501.2-2001
Connectors for use in d.c.，low-frequency analogue and digital high speed data spplications--Part 2:Circular connectors with assessed quality--Sectional specification
GB/T 18501.1-2001
Connectors with assessed quality，for use in d.c.，low frequency analogue and in digital high speed data applications--Part 1:Generic specification
GB/T 18496-2001
Electromechanical switches for use in electronic equipment--Part 4:Sectional specification for lever(toggle) switches
GB/T 17562.1-1998
Rectangular connectors for frequencies below 3 MHz--Part 1: Generic specification--General requirements and guide for the preparation of detail specifications for connectors with assessed quality
GB/T 13420-1998
Electromechanical switches for use in electronic equipment--Part 6:Sectional specification for sensitive switches--Section 1:Blank detail specification
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.