GB/T 3106-2016
ActiveFasteners—Bolts,screws and studs—Nominal lengths and thread lengths
紧固件 螺栓、螺钉和螺柱 公称长度和螺纹长度
Application Summary AI generated
This standard specifies the nominal lengths and corresponding thread lengths for bolts, screws, and studs, ensuring dimensional consistency across mechanical fasteners. It is applied in the design, manufacturing, and procurement of threaded fasteners for general engineering, automotive, and construction industries. The standard facilitates interchangeability and compatibility in assembly processes by defining standardized length-to-thread ratios.
Related Standards
GB/T 62.3-2004
Wing nuts--Pressing wing
GB/T 9074.5-2004
Cross recessed small pan head screw andwasher assemblies with plain washers
GB/T 62.2-2004
Wing nuts--Square wing
GB/T 62.1-2004
Wing nuts--Round wing
GB/T 9074.20-2004
Cross recessed hexagon head tapping screw with indentation and washer assemblies with plain washers
GB/T 3098.20-2004
Mechanical properties of fasteners--Wing nuts with specified proof torque
GB/T 62.4-2004
Wing nuts--Die-casting wing
GB/T 3098.19-2004
Mechanical properties of fasteners--Blind rivets with break pull mandrel
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.