GB/T 3098.13-1996
ActiveMechanical properties of fasteners--Torsional test and minimum torques for bolts and screws with nominal diameters from 1mm to 10mm
紧固件机械性能 螺栓与螺钉的扭矩试验和破坏扭矩公称直径1～10mm
Application Summary AI generated
This standard specifies the torsional test method and minimum torque values for bolts and screws with nominal diameters from 1mm to 10mm. It is applied in the quality control and mechanical testing of small fasteners used in automotive, electronics, and general machinery assemblies. The standard ensures that these fasteners can withstand specified torsional loads without failure during installation or service.
Related Standards
GB/T 9074.5-2004
Cross recessed small pan head screw andwasher assemblies with plain washers
GB/T 62.3-2004
Wing nuts--Pressing wing
GB/T 62.2-2004
Wing nuts--Square wing
GB/T 9074.20-2004
Cross recessed hexagon head tapping screw with indentation and washer assemblies with plain washers
GB/T 62.1-2004
Wing nuts--Round wing
GB/T 3098.20-2004
Mechanical properties of fasteners--Wing nuts with specified proof torque
GB/T 62.4-2004
Wing nuts--Die-casting wing
GB/T 3098.19-2004
Mechanical properties of fasteners--Blind rivets with break pull mandrel
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.