GB/T 30104.206-2013
ActiveDigital addressable lighting interface―Part 206: Particular requirements for control gear―Conversion from digital signal into d. c. voltage (device type 5)
数字可寻址照明接口 第206部分：控制装置的特殊要求 数字信号转换成直流电压（设备类型5）
Application Summary AI generated
This standard specifies the protocol and testing requirements for control gear that converts digital addressable lighting interface (DALI) signals into a direct current (DC) voltage output, specifically for device type 5. It is applied in digital lighting control systems where a DALI bus command must drive non-dimmable LED modules, analog dimmers, or other voltage-controlled lighting loads. The standard ensures interoperability and consistent performance between DALI controllers and voltage-output control gear in commercial, industrial, and architectural lighting installations.
Related Standards
GB/T 19656-2005
DC supplied electronic ballasts for tubular fluorescent lamps--Performance requirements
GB/T 19657-2005
Heat test source(H.T.S)lamps for carrying out heating tests on luminaires
GB/T 19654-2005
Auxiliaries for lamps--D.C.or A.C.supplied electronic step-down convertors for filament lamps Performance requirements
GB/T 13259-2005
High Pressure Sodium Lamps
GB/T 19653-2005
Installation rule for neon tubes
GB/T 24827-2026
Performance specifications of luminaires for road and street lighting
GB/Z 23153-2008
Disassembly requirements for testing hazardous substances in lighing equipment
GB/Z 30418-2013
Luminaires—Application of the IK code
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.