GB/T 19701.2-2005
AbolishedImplants for surgery Ultra-high molecular weight polyethylene-part 2:Moulded forms
外科植入物 超高分子量聚乙烯 第2部分:模塑料
Application Summary AI generated
This standard specifies the requirements and test methods for moulded forms of ultra-high molecular weight polyethylene (UHMWPE) used in surgical implants. It is applied in the manufacturing and quality control of orthopedic devices such as artificial hip and knee joint components, ensuring material consistency and biocompatibility for long-term implantation in the human body.
Related Standards
GB/T 19381-2003
General methods of test for medical closures of butyl rubber
GB/T 14214-2003
Spectacle frames--General requirements and test methods
GB/T 18375.6-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 6:Loading parameters of supplementary structural tests
GB/T 18375.7-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 7:Test submission document
GB/T 18375.5-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 5:Supplementary structural tests
GB/T 19543-2004
Prostheses--Structural testing of hip units
GB/T 18375.8-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 8:Test report
GB/T 19629-2005
Medical Electrical Equipment-Dosimeters with ionization chambers and/or semi-conductors as used in X-ray diagnostic imaging
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.